Dc 100v 10A Voltmeter Ammeter DSN Description Name: DC Volt and Amp Meter Voltmeter & Ammeter 2 in 1 Tester Voltage Measuring Range: DC 0.0V-100V Current Measuring Range: DC 0-10A Operating Voltage: DC 4-30V Operating Current: Less than 20mA Voltage Resolution (V): /- 0.1% Current Resolution (A): /- 1% Refresh Rate: About 300mS/times Operating temperature: -10 to 65 degree Display: Three 0.28″ LED digital tube Display Color: Red and Blue (two-color display) Cable Length: 15cm Dimensions: 48x29x22mm (LxWxT) Mounting Hole: 46x27mm Feature: High precision, high reliability, for high-end applications. Function: With reverse connection protection Applications: Suitable for automotive/electric cars/motorcycles battery monitoring or other products voltage current measurement DC 100V 10A Voltmeter Dc 100v 10A Voltmeter Ammeter DSN Features This DC 100V 10A Ammeter Voltmeter is consist of 0.28 inch 5 wire red LED. With 100V DC can be measured by this meter with 0.1V resolution. This volt ammeter contains 2 wire harnesses. 2 poles with RED and BLACK lead used to provide power for the meters. this meter is portable and small in size. DSN-VC288 DC 100V 10A shows volt and ammeter at the same time on the same screen. Its operating voltages are 6 to 30 volts. This is a separate power supply that is isolated from the source, it is possible to use the same supply but it seems to affect the amp meter reading. 3 wire harness used for a ground. This 3rd wire harness connects directly to the battery or supply ground of the load. Get all types of Meters, Sensors, Modules Operating voltage: DC 4.5 – 30V Measure voltage: DC 0 – 100V Minimum resolution(V): 0.1V Measure current :10A (measure directly ,built-in shunt) Minimum resolution(A): 0.01A Operating current: <20mA Display color: Red and Blue (two-color display) Dimensions: 48 x 29 x 21mm Mounting cutout: 45.5 x 26.5mm Refresh rate: about 500mS / times Measure accuracy: 1% (± 1 digit) Operating temperature: -10 to 65° c Operating Humidity: 10 to 80% (non-condensing) Applications :Suitable for automotive/electric cars/motorcycles battery monitoring or other products voltage current measurement en.wikipedia.org Notice: The voltage between the thin red and thin black lines must be within DC 4.5-30V The ammeter can only be connected to the negative of the device under test 10A below ammeter (include 10A), built-in shunt, does not require external shunt When the black thin line vacant, it is better to use insulating tape around the exposed part of the wire, to prevent short circuits If just be used as a voltmeter, it is recommended that the yellow line and the black line were connected together, to prevent the ammeter digital flashing
